problem with Artemis crashing on mac
Hello all, I was wondering whether anyone had experienced this problem or had some advice for what I can try. I have Demeter installed successfully on my mac (Yosemite 10.10.5). Athena works just fine. However, when I try running Artemis, it begins to open fine and all the GUI windows look good, but then a popup that says 'Restore from an autosave file' with buttons for 'Cancel' or 'OK' appears. I'm not able to click on anything and the program does not progress from this point. I don't remember this happening when I first installed. Is there an easy way to go in and trash some potential autosave file I have that is causing problems? If so, where would that be located? I dug around a bit, but couldn't find anything obvious. It's a little odd, because I've not really used the program. I simply tested it when I first installed to ensure it worked and that was it. Any thoughts or comments would be useful. If additional information would help in diagnosing the issue, I'm happy to provide it. Thanks, Kate
On 02/16/2016 09:06 PM, Katherine M. Davis wrote:
I was wondering whether anyone had experienced this problem or had some advice for what I can try.
I have Demeter installed successfully on my mac (Yosemite 10.10.5). Athena works just fine. However, when I try running Artemis, it begins to open fine and all the GUI windows look good, but then a popup that says 'Restore from an autosave file' with buttons for 'Cancel' or 'OK' appears. I'm not able to click on anything and the program does not progress from this point. I don't remember this happening when I first installed. Is there an easy way to go in and trash some potential autosave file I have that is causing problems? If so, where would that be located? I dug around a bit, but couldn't find anything obvious. It's a little odd, because I've not really used the program. I simply tested it when I first installed to ensure it worked and that was it.
Any thoughts or comments would be useful. If additional information would help in diagnosing the issue, I'm happy to provide it.
Hi Kate, Without some hint from screen messages or some such, there is not much chance of my troubleshooting the problem. I think the easiest work-around is to simply disable the use of the autosave file. This is normally done by setting the Artemis-->autosave parameter to false using the preferences tool in Artemis. Obviously that's a problem. There are two solutions: 1. Figure out where the autosave file is on disk. It's called "artemis.autosave" -- I think. It certainly is something.autosave. 2. Find the "demeter.ini" file (should be in $HOME/.horae) and edit it with a text editor. Find the [artemis] section, change "autosave" to "false". That should make the problem go away, at the cost of not having an autosave feature. HTH, B -- Bruce Ravel ------------------------------------ bravel@bnl.gov National Institute of Standards and Technology Synchrotron Science Group at NSLS-II Building 535A Upton NY, 11973 Homepage: http://bruceravel.github.io/home/ Software: https://github.com/bruceravel Demeter: http://bruceravel.github.io/demeter/
participants (2)
-
Bruce Ravel
-
Katherine M. Davis