Hello there I got an issue with k-weight of fit whileexporting the fit from ARTEMIS I fitted the data in k2, but it is exporting k3. I saved the fit at k2 weight and when I opened again, it was again set at k3. Is there any way I could choose the k-weight of my choice while exporting? Regards Manju Junior Research Fellow Department of Basic and Applied Sciences Punjabi University, Patiala- 147 002 Punjab, India.
Hi Manju,
I had the same problem. The solution I found that worked for me was to use
"save next plot to a file" at the bottom of main artemis window instead of
exporting it from data window.
Hope this helps!
Regards,
Natasa
On Fri, 19 Jun 2020 at 18:20, Manju
Hello there
I got an issue with k-weight of fit whileexporting the fit from ARTEMIS I fitted the data in k2, but it is exporting k3. I saved the fit at k2 weight and when I opened again, it was again set at k3. Is there any way I could choose the k-weight of my choice while exporting?
Regards Manju Junior Research Fellow Department of Basic and Applied Sciences Punjabi University, Patiala- 147 002 Punjab, India.
_______________________________________________ Ifeffit mailing list Ifeffit@millenia.cars.aps.anl.gov http://millenia.cars.aps.anl.gov/mailman/listinfo/ifeffit Unsubscribe: http://millenia.cars.aps.anl.gov/mailman/options/ifeffit
participants (2)
-
Manju
-
Natasa Diklic