Hello All, I have enjoyed this digest in the past and found it very helpful! I hope it may provide an answer to my question. I am collecting Mn EXAFS data out to k of 15 Å-1, and the data look fine. However, the monochromator (Si 111) has 5 strong 2-point glitches and 3 minor 1-point glitches in one of the regions that I am most interested in (k between 5 and 9 Å-1). My question relates to how many data points I can remove before influencing the data. In my previous experience I have removed 2 or 3 points but never more. I have read through the deglitching section of “XAFS for Everyone”, and think that I could oversample the EXAFS (with k steps of 0.03 Å-1 vs 0.05 Å-1), but most of the data have already been collected. Is there a rule of thumb about deglitching? In other words, is there a limit to the number of bad points I can eliminate for an EXAFS scan to k of 15 Å-1? Thanks and looking forward to hearing your thoughts, Francesco Francesco Femi Marafatto francesco.marafatto@unil.ch FNS PhD student, Environmental Geochemistry Laboratory IDyST - FGSE Bureau 3233 Gèopolis Université de Lausanne CH-1015 Lausanne T. +41 (0)21 692 4451