Hello - We're trying to install demeter on a 32-bit system running Debian 9.2 Stretch. The 'perl Build.PL' and 'Build' run into no issues, but when we try running 'Build test' we get the following error messages: t/001_base.t ............ String found where operator expected at /home/kwiatal/sources/demeter-master/blib/lib/Demeter/Plot/Gnuplot.pm line 273, near "croak "Couldn't unlink $self->{__error_log}: $!"" (Do you need to predeclare croak?) syntax error at /home/kwiatal/sources/demeter-master/blib/lib/Demeter/Plot/Gnuplot.pm line 273, near "croak "Couldn't unlink $self->{__error_log}: $!"" Compilation failed in require at /home/kwiatal/sources/demeter-master/blib/lib/Demeter.pm line 244. Compilation failed in require at t/001_base.t line 22. BEGIN failed--compilation aborted at t/001_base.t line 22. # Looks like your test exited with 255 before it could output anything. t/001_base.t ............ Failed 24/24 subtests t/002_types.t ........... String found where operator expected at /home/kwiatal/sources/demeter-master/blib/lib/Demeter/Plot/Gnuplot.pm line 273, near "croak "Couldn't unlink $self->{__error_log}: $!"" (Do you need to predeclare croak?) syntax error at /home/kwiatal/sources/demeter-master/blib/lib/Demeter/Plot/Gnuplot.pm line 273, near "croak "Couldn't unlink $self->{__error_log}: $!"" Compilation failed in require at /home/kwiatal/sources/demeter-master/blib/lib/Demeter.pm line 244. The "croak" command not getting found appears to come from the "Carp" perl module - we have version 6.06-1 of the 'libcarp-clan-perl' package installed. Any suggestions as to what's causing this error? Again, the 'perl Build.PL' command shows no issues with the installed modules, but since most of them were installed from the Debian repository, maybe there's a discrepancy with the modules installed when we run './Build installdeps'? Thanks for any assistance - Al Kwiatkowski kwiatal@phys.iit.edu