You didn't say what you're trying to find out or even which edge you're doing this at. That being the case, it's a little hard to know what the best strategy is. A few things come to mind: 1. If you're looking for the environment of the Ga, then obviously, BaO and Ti2O3 aren't terribly useful. You'd want something with Ga in an environment similar to that of the unknown. Is there such a thing as BaGa8Ox with the same structure as BaTi8O16, which I assume is known? Another possibility is to use as a reference something in which instead of Ga as the central atom, you have something nearby in the periodic table, but in a similar environment. Ga2O3 would only be useful if all you're after is Ga-O and maybe Ga-Ga distances. Check for other, known oxides in the Ba-Ti-Ga-O system or at least Ba-Ga-O or Ti-Ga-O. 2. If you're after what the Ga does to the environment of the major elements, then perhaps you could use BaTi8O16 (if that exists)or barium titanate. These would give you the Ba-O, Ti-O, and (Ba,Ti)-(Ba,Ti) paths. My intuitive guess is that if x is small, then you'd be looking for small changes, so the best standard of all is the x=0 material, if it exists. Fit that, then add in (Ba,Ti)-Ga paths as appropriate and let the other paths change and see what happens for x >0. 3. Is the doped material available as a single crystal? Has the structure been solved? Perhaps that information could be used to constrain the structure. 4. The stoichiometry you give, Ba(Ti,Ga)8O16, requires the (Ti,Ga) to be in a mixed-valent state (assuming Ba=2, average = 30/8 = 15/4 = 3.75). That being the case, I'm guessing that the Ga substitutes for the Ti3+, either shifting the average valence so that O isn't 16 anymore or just replacing the Ti3+ until you've replaced it all. Either way, Ti XANES would be informative. There are many papers about the interpretation of Ti K-edge XANES. 5. If my guess about Ga substituting only for Ti3+ is correct, *and* you quoted the correct stoichiometry, then, a) Something should happen for x>2 because you can't get an average valence of 3.75 anymore. b) If the Ti3+ and Ti4+ sites are different enough, say octahedral+tetrahedral, then the Ga EXAFS should look like that of the Ti3+ only. c) Ga3+ is slightly smaller than Ti3+, so you might see a small contraction around the Ga relative to the Ti. Good luck. mam On 11/18/2014 2:32 PM, Yun Xu wrote:
Hi all I have a complex oxide BaTi8-xGaxO16. What standards I should run? Ga is the dopant. I guess I should run the sample without dopant BaTi8O16 as standard, or the simple oxide as BaO, TiO2 Ga2O3? or is the standard necessary? Also, I have colleage working on DFT, I assume the theoretical standard is the result from the DFT calculation, and by using the coordinates of the atoms, I can run FEFF and fit the data. Thanks Yun
_______________________________________________ Ifeffit mailing list Ifeffit@millenia.cars.aps.anl.gov http://millenia.cars.aps.anl.gov/mailman/listinfo/ifeffit