On 09/04/2015 02:54 PM, Robert Gordon wrote:
Terminal Your value qt
Demeter.ini says wxt
I change the Set value to wxt and apply & save. message at bottom of screen says "Now using wxt for gnuplot --> terminal and an ini file was saved"
Plucked point is now consistent.
However, when I exit and re-start Athena, back to qt and problem re-appears. In demeter.ini, [gnuplot] section, it still says terminal = wxt, but under preferences,gnuplot terminal it is back to qt.
If I change to x11, and restart, x11 is remembered. If I change to wxt from x11, apply and save, it resets to qt when restarting even though the ini file says wxt.
Ugh! I thought I had fixed that problem. Top of the to do list for Tuesday morning. Thanks, B -- Bruce Ravel ------------------------------------ bravel@bnl.gov National Institute of Standards and Technology Synchrotron Science Group at NSLS-II Building 535A Upton NY, 11973 Homepage: http://bruceravel.github.io/home/ Software: https://github.com/bruceravel Demeter: http://bruceravel.github.io/demeter/