Hi folks! Well, it didn't take me very long to find several very serious bugs in the multiple-data-set version of artemis that I released the other day. I was able to fix most of them and have posted new tarballs and windows executables. One problem had to do with the first path in a fit sometimes being neglected by Artemis. Yikes! The other problem had to do with sving and rereading project files multiple data sets. Both of these and a few smaller problems are fixed in version 0.6.002. One problem which remains is in the brand new Project Assistant. Suppose that you want to fit several scans of the same material measured at different temparatures. In that case you would want to import several data files and then import the same feff calculation(s) for each data file. If you attempt to import the same feff calculation more than once with the Project Assistant, it will not do the right thing. Other uses of the Project Assistant, including single data set fits and multiple data set fits with *different* feff calculations, *will* work as intended. Also, if you import your data and feff calculations outside the Project Assistant (i.e. by using the appropriate entries in the File menu), then you can set up a multiple-temperature fit. So, if you want to do a fit with many data sets and a single feff calculation which is used repeatedly, you must set it up by hand and not by using the Project Assistant. This will be fixed in 0.6.003. Regards, B -- Bruce Ravel ----------------------------------- ravel@phys.washington.edu Code 6134, Building 3, Room 222 Naval Research Laboratory phone: (1) 202 767 5947 Washington DC 20375, USA fax: (1) 202 767 1697 NRL Synchrotron Radiation Consortium (NRL-SRC) Beamlines X11a, X11b, X23b, X24c, U4b National Synchrotron Light Source Brookhaven National Laboratory, Upton, NY 11973 My homepage: http://feff.phys.washington.edu/~ravel EXAFS software: http://feff.phys.washington.edu/~ravel/software/exafs/