On Thursday, September 27, 2012 11:58:30 AM Jeremy Thorbahn wrote:
Since I upgraded to the Demeter version of Athena some months ago, I have been basically unable to use it for some of my data since immediately upon import, the program shuts itself down with no message. I have Athena 0.8.056 installed as well and do not have the same issue there, so I have been using that version just fine but I thought I should report this issue or seek advice if it is a fault of my data and not the program.
I have 0.9.12 and the issue persists. It only occurs with my set of data from the HXMA beamline at the Canadian Light Source as well, I have successfully imported data from other beamlines.
I also want to point out that you should not have been surprised that this issue persisted in 0.9.12. I cannot fix problems that I do not know about. Until you told me this, I did not know it was a problem. As I say often, I am very grateful when people make a bug report. It is only through this sort of communication that the software can improve. Thanks, B -- Bruce Ravel ------------------------------------ bravel@bnl.gov National Institute of Standards and Technology Synchrotron Methods Group at NSLS --- Beamlines U7A, X24A, X23A2 Building 535A Upton NY, 11973 Homepage: http://xafs.org/BruceRavel Software: https://github.com/bruceravel