Hi, A minor (I hope) request for D-Athena on PC's. When running a LCF (eg collected a spectrum and named it AsScan1) and exporting the LCF predicted results to an excel file, the default name of the newly created xls file is "combinatorial.xls". In Athena (on PC) the default output file name was the name of the spectra you are fitting (eg AsScan1.cvs). If the default in D-Athena could be the name of the original spectra again that would be very appreciated. If it could be the name of the spectra and the name of the fit space (eg. AsScan1.derv.xls or AsScan1.norm.xls or AsScan1.Chi.xls)... I may have to dance a jig in your honor. Thanks for your time and the freeware. Respectfully, Bradley W. Miller, Ph.D. Post Doctoral Fellow Oak Ridge Institute for Science and Education U. S. Environmental Protection Agency National Risk Management Research Laboratory Land Remediation and Pollution Control Division 5995 Center Hill Avenue, Cincinnati, OH 45224-1702 Office: (513) 487-2889 Miller.BradleyW@epa.gov Fax: (513) 569-7879 www.epa.gov www.tinyurl.com/bwmiller The great tragedy of Science—the slaying of beautiful hypothesis by an ugly fact.— Thomas H. Huxley Views or Opinions expressed in this email is solely representative of the sender and does not represents those of the EPA or any other agency.