[Ifeffit] current-amp recommendation
Carlo Segre
segre at iit.edu
Tue Nov 14 15:32:41 CST 2017
HI Matthew:
One possibility is the Caen quad amplifier that they made for BPMs.
http://www.caenels.com/products/tetramm/
Carlo
On Tue, 14 Nov 2017, Matthew Marcus wrote:
> I've gotten involved with a project in which stabilization of the position of
> a monochromatic, soft X-ray beam is needed. The
> offending frequencies seem to be vibration frequencies like 57 and 116Hz. We
> have in mind to use a thin Au film with a gap in the
> middle, measuring the drain current from the films, much as people normally
> use the jaws of slits. Now, I'd like to find a couple
> of current amplifiers which are small enough so that they can be connected
> with very short cables to the BNC connectors on the
> air-side of this detector, and which would have decent frequency response and
> low noise with inputs of the order of 0.1-1nA.
> Although this topic is outside the realm of XAFS analysis with IFEFFIT, I
> figure that people on this group might have some
> good experience.
>
> mam
> _______________________________________________
> Ifeffit mailing list
> Ifeffit at millenia.cars.aps.anl.gov
> http://millenia.cars.aps.anl.gov/mailman/listinfo/ifeffit
> Unsubscribe: http://millenia.cars.aps.anl.gov/mailman/options/ifeffit
>
--
Carlo U. Segre -- Duchossois Leadership Professor of Physics
Interim Chair, Department of Chemistry
Director, Center for Synchrotron Radiation Research and Instrumentation
Illinois Institute of Technology
Voice: 312.567.3498 Fax: 312.567.3494
segre at iit.edu http://phys.iit.edu/~segre segre at debian.org
More information about the Ifeffit
mailing list