[Ifeffit] Fwd: help about Arthemis

[Bruce Ravel]

Mahendra,

I am forwarding your question and my answer to the Ifeffit mailing list.  I
recommend that you make use of that resource for your EXAFS and analysis
software questions.

Once you make the sum of paths, you should find that, in the File menu, the
menu item for "Save fit as" is enabled.  I acknowledge that is somewhat
confusing -- you made a summation, not a fit.  But as far as Artemis is
concerned, summations and fits are very similar.  In any case, you can use
that item in the File menu to save your summation in k, R, or q space.

There is a small bug in there.  If you have not imported data yet, you can
still save the summation in the manner I described, but the information
written to the header will be incorrect.  That will not preclude using the
file, however.

Hope that helps,
B



----------  Forwarded Message  ----------

Subject: help about Arthemis
Date: Friday 29 April 2005 15:19
From: koppolu uma mahendra kumar <mahixs at gmail.com>
To: ravel at phys.washington.edu

Dear Dr.Bruce Ravel,
                  i am a new user of Arthemis.
i calculated an exafs signal using phase and amplitudes calculated from 
 Feff. i used the option "sum of paths(no fit)" in Arthemis.
i am not able to save this as an ascii file.
Please help me to go ahead.
thanking you
mahendra kumar

-------------------------------------------------------

-- 
 Bruce Ravel  ----------------------------------- bravel at anl.gov  -or-
						  ravel at phys.washington.edu
 Environmental Research Division, Building 203, Room E-165
 Argonne National Laboratory                        phone: (1) 630 252 5033
 Argonne IL 60439, USA                                fax: (1) 630 252 9793

 My homepage:    http://feff.phys.washington.edu/~ravel 
 EXAFS software: http://feff.phys.washington.edu/~ravel/software/exafs/