[Ifeffit] Trying to get started
Bruce Ravel
ravel at phys.washington.edu
Mon Feb 9 08:27:33 CST 2004
On Saturday 07 February 2004 11:05 pm, doug pease wrote:
> I am trying to get started using Athena/Artemis. But I have the following
> problem. My computer is nearly brand new, uses XP and I now have 384 MB of
> RAM to go along with only 2.71 out of 35.54 GB used on the hard drive. But
> after I import data into Athena, and give the go ahead, the graphic screen
> just comes up and hangs up blank. It does NOT graph the data.
I just fired up my Windows virtual machine and download the latest
ifeffit installer to see what happens.
I see the same behavior as Doug and Scott report. What's more, I see
the same behavior using the ifeffit command line program. That is,
running "ifeffit" from the DOS prompt, then entering these two
commands
read_data(file=cu010k.dat, group=a)
plot(a.energy, a.xmu)
crashes ifeffit.
I don't have any advice at this point, particularly in light of
Michel's report.
I will state (again) that a small number of dedicated pre-testing
volunteers could go a long way towards rooting out these problems
*before* they get widely released. Of course, I have asked for
volunteers of this sort in the past and have received, at best,
unfulfilled promises. But I am willing once again to do my best Don
Quixote impression....
B
--
Bruce Ravel ----------------------------------- ravel at phys.washington.edu
Code 6134, Building 3, Room 222
Naval Research Laboratory phone: (1) 202 767 5947
Washington DC 20375, USA fax: (1) 202 767 1697
NRL Synchrotron Radiation Consortium (NRL-SRC)
Beamlines X11a, X11b, X23b
National Synchrotron Light Source
Brookhaven National Laboratory, Upton, NY 11973
My homepage: http://feff.phys.washington.edu/~ravel
EXAFS software: http://feff.phys.washington.edu/~ravel/software/exafs/
More information about the Ifeffit
mailing list