Dear all, I measured Na2Ti3O7 with Pb replacing Na. I measured the L3 edge in transmission mode. Mainly all samples have noise at k>8 but two of them show the "same noise". Pb0375 replaces 18% of Na by Pb while Pb1000 replaces 50%.

Dear all,

I measured Na2Ti3O7 with Pb replacing Na.
I measured the L3 edge in transmission mode.
Mainly all samples have noise at k>8 but two of them show the "same noise".

Pb0375 replaces 18% of Na by Pb while Pb1000 replaces 50%.

I would like to know if this is a signal to pay attention or just cut it off.

I am planning to measure at low temperatures in the next call.

Any suggestion is welcome.

I also attach the csv of the samples and PbO2 std.
Best regards.

(^ㅇᆽㅇ^)(=˃ᆺ˂=)(=🝦 ༝ 🝦=)

Eugenio H. OTAL

Assistant Professor
Research Initiative for Supra Materials,
Shinshu University
4-17-1 Wakasato, Nagano city.
380-8553, Japan
eugenio_otal@shinshu-u.ac.jp

¯\_(ツ)_/¯ ¯\_(ツ)_/¯

Who is John Galt?

¯\_(ツ)_/¯ ¯\_(ツ)_/¯