Bruce,
On Thursday, September 27, 2012 11:58:30 AM Jeremy Thorbahn wrote:
> Since I upgraded to the Demeter version of Athena some months ago, I haveI also want to point out that you should not have been surprised that
> been basically unable to use it for some of my data since immediately upon
> import, the program shuts itself down with no message. I have Athena
> 0.8.056 installed as well and do not have the same issue there, so I have
> been using that version just fine but I thought I should report this issue
> or seek advice if it is a fault of my data and not the program.
>
> I have 0.9.12 and the issue persists. It only occurs with my set of data
> from the HXMA beamline at the Canadian Light Source as well, I have
> successfully imported data from other beamlines.
this issue persisted in 0.9.12. I cannot fix problems that I do not
know about. Until you told me this, I did not know it was a problem.
As I say often, I am very grateful when people make a bug report. It
is only through this sort of communication that the software can
improve.
Thanks,
B_______________________________________________
--
Bruce Ravel ------------------------------------ bravel@bnl.gov
National Institute of Standards and Technology
Synchrotron Methods Group at NSLS --- Beamlines U7A, X24A, X23A2
Building 535A
Upton NY, 11973
Homepage: http://xafs.org/BruceRavel
Software: https://github.com/bruceravel
Ifeffit mailing list
Ifeffit@millenia.cars.aps.anl.gov
http://millenia.cars.aps.anl.gov/mailman/listinfo/ifeffit