Hi all,

I have another quick question about saving & loading Feff fittings. Let’s say I have a good Feff fitting for my XAFS spectrum. How to save my fitting project for the future refinement?

I checked the xas_viewer document in the Larch site. It only mentioned how to save a pre-edge peak fitting, and there is no content about saving and loading about Feff fittings. The file bottom at the tool bar of the Feffit Result window seems saves everything (e.g., paths used, fitting parameters, and even fitting plots). But there is no “load” bottom at that window, therefore the saved fittings are not recoverable.

Best,

Juejing

Juejing Liu

Guo Group

Materials Science and Engineering program

Alexandra Navrotsky Institute for Experimental Thermodynamics

Washington State University
Pullman, WA  99164-4630
Office: Fulmer Hall, Room 630
Phone: 208-206-7304