Hi Bruce,

I don't find "athena preferences menu" when I open athena... I can only see "service preferences" under perl5.22, which is the preferences for my mac not for athena...

I just found if I set terminal to qt, it showed "unknown". If I set to x11, it showed "nopersist enhanced". If I set to wxt, it showed "0 enhanced". Are these normal?

Thanks,

Chloe

On Wed, Oct 7, 2015 at 12:26 PM, Chloe Yi-Yi Wu <yiyiwu2016@u.northwestern.edu> wrote:

Hi Bruce,

I just upgraded my mac from mountain lion to el capitan. I was using the old version, iXAFS, but I can't launch it on the new el capitan. I then installed Demeter with Macport by following the instructions. However, I'm not able to plot the data in athena and artemis.

I read the thread about "no plot window on Yosemite", but still have no clue. I can plot gnuplot in aqua, x11 and wxt. It seems whenever I quit gnuplot to launch athena and enter gnuplot later again, it will always go back my default terminal, aqua, no matter how I set terminal. Is there a communication problem between Demeter and aqua? I'm not familiar with these commands, to be honest. If I did something wrong, please advise.

Thanks,
Chloe

--
Yi-Yi (Chloe) Wu
Kung Research Group
Dept. of Chemical and Biological Engineering
Northwestern University
Evanston, IL USA

Yi-Yi (Chloe) Wu
Kung Research Group
Dept. of Chemical and Biological Engineering
Northwestern University
Evanston, IL USA