Hi All,
I'm doing Scott's posted tutorial on ZnO and found that the step-by-step instructions in the journal for the first project part (very first fitting) don't contain the step of creating guess parameters (amp, E0, etc.) and giving a value to them. After selecting the R range, the tutorial goes right to hitting the "Fit" button. I think this step (defining guess and path parameters) is imporant to indicate for beginners.
Also, the tutorial says:
"If the fit does not appear to match what is described below, go to Settings, then Edit Preferences, autoparams, do_autoparams, and check the red box. Save changes for future sessions, then Quit Artemis without saving the project and start again. If you are using a copy of Artemis which belongs to someone else, change it back later so they don't yell at you."
I could not find the Edit Preferences option under Settings at all. Is this a problem with my version (0.6.005)/copy?
Thanks,

Tamas

*********************************************************************************
Tamas Varga
School of Chemistry and Biochemistry
GeorgiaInstitute
of
Technology
770 State Street
Atlanta, GA 30332-0400
Phone: 404 894 9493 (W), 404 892 0290 (H)